Users Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S8420T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
DellEMC# show running-config lldp
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
hello 15
multiplier 3
no disable
DellEMC#
snmp-notification-interval
Used to configure the value for the lldp notification interval, to throttle lldp notification messages.
Syntax
[no] snmp-notification-interval [seconds]
To disable this feature, use the no snmp-notification-interval command.
Parameters
seconds Enter a value from 5 to 3600 seconds.
Defaults 5 seconds
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(2.5) Introduced on the S3048–ON, S4048–ON, S4048T-ON, S6010–ON and Z9100–ON
Usage
Information
SNMP notification for the changes in the lldp remote entry table is throttled by 5 seconds (default), or
the configured time set using this command. If more than one notification message is generated within
the configured time, only the first one will be sent and the remaining messages are suppressed.
LLDP-MED Commands
The following are the LLDP-MED (Media Endpoint Discovery) commands.
Dell EMC Networking OS LLDP-MED commands are an extension of the set of LLDP TLV advertisement commands.
990
Link Layer Discovery Protocol (LLDP)