Service Manual

NOTE: The command line help still displays relevant details corresponding to each of these
commands. However, these interface range or interface group commands are not supported when
Management VRF is configured.
Configuring a Static Route
To configure a static route, perform the following steps:
Task Command Syntax Command Mode
Configure a static route that
points to a management
interface.
management route ip-
address mask
managementethernet
ormanagement route ipv6-
address prefix-length
managementethernet
NOTE: You can also have
the management route to
point to a front-end port in
case of the management
VRF. For example:
management route 2::/64 te
0/0.
CONFIGURATION
To configure a static entry in the IPv6 neighbor discovery, perform the following steps:
Task Command Syntax Command Mode
Configure a static neighbor.
ipv6 neighbor vrf
management 1::1
tengigabitethernet 1/1
xx:xx:xx:xx:xx:xx
CONFIGURATION
Sample VRF Configuration
The following configuration illustrates a typical VRF set-up.
Virtual Routing and Forwarding (VRF)
1075