Service Manual

Important Points to Remember
• Link dampening is not supported on VLAN interfaces.
• Link dampening is disabled when the interface is configured for port monitoring.
• You can apply link dampening to Layer 2 and Layer 3 interfaces.
• You can configure link dampening on individual interfaces in a LAG.
Enabling Link Dampening
To enable link dampening, use the following command.
• Enable link dampening.
INTERFACE mode
dampening
Examples of the show interfaces dampening Commands
To view the link dampening configuration on an interface, use the show config command.
R1(conf-if-te-1/1)#show config
!
interface TenGigabitEthernet 1/1
ip address 10.10.19.1/24
dampening 1 2 3 4
no shutdown
To view dampening information on all or specific dampened interfaces, use the show interfaces
dampening command from EXEC Privilege mode.
Dell# show interfaces dampening
InterfaceStateFlapsPenaltyHalf-LifeReuseSuppressMax-Sup
Te 1/1Up005750250020
Te 1/2Up21200205001500300
Te 1/2Down4850306002000120
To view a dampening summary for the entire system, use the show interfaces dampening summary
command from EXEC Privilege mode.
Dell# show interfaces dampening summary
20 interfaces are configured with dampening. 3 interfaces are currently
suppressed.
Following interfaces are currently suppressed:
Te 1/2
Te 3/1
Te 4/2
Dell#
Clearing Dampening Counters
To clear dampening counters and accumulated penalties, use the following command.
• Clear dampening counters.
clear dampening
Interfaces
447