Service Manual

tunnel mode ipip decapsulate-any
no shutdown
Configuring the Tunnel Source Anylocal
You can use the anylocal argument in place of the ip address or interface, but only with multipoint
receive-only mode tunnels. The
tunnel source anylocal command allows the multipoint receive-
only tunnel to decapsulate tunnel packets addressed to any IPv4 or IPv6 (depending on the tunnel mode)
address configured on the switch that is operationally UP.
The following sample configuration shows the tunnel source anylocal command:
Dell(conf)#interface tunnel 1
Dell(conf-if-tu-1)#ipv6 address 1abd::1/64
Dell(conf-if-tu-1)#ip address 1.1.1.1/24
Dell(conf-if-tu-1)#tunnel source anylocal
Dell(conf-if-tu-1)#tunnel mode ipip decapsulate-any
Dell(conf-if-tu-1)#tunnel allow-remote 40.1.1.2
Dell(conf-if-tu-1)#no shutdown
Dell(conf-if-tu-1)#show config
!
interface Tunnel 1
ip address 1.1.1.1/24
ipv6 address 1abd::1/64
tunnel source anylocal
tunnel allow-remote 40.1.1.2
tunnel mode ipip decapsulate-any
no shutdown
Tunneling
973