Administrator Guide
• Defining Interface Range Macros
• Monitoring and Maintaining Interfaces
• Non Dell-Qualified Transceivers
• Splitting 40G Ports without Reload
• Splitting QSFP Ports to SFP+ Ports
• Converting a QSFP or QSFP+ Port to an SFP or SFP+ Port
• Configuring wavelength for 10–Gigabit SFP+ optics
• Link Dampening
• Link Bundle Monitoring
• Using Ethernet Pause Frames for Flow Control
• Configure the MTU Size on an Interface
• Port-Pipes
• Auto-Negotiation on Ethernet Interfaces
• View Advanced Interface Information
• Configuring the Traffic Sampling Size Globally
• Dynamic Counters
• Discard Counters
Interface Types
The following table describes different interface types.
Table 41. Different Types of Interfaces
Interface Type Modes Possible Default Mode Requires Creation Default State
Physical L2, L3 Unset No Shutdown (disabled)
Management N/A N/A No No Shutdown (enabled)
Loopback L3 L3 Yes No Shutdown (enabled)
Null N/A N/A No Enabled
Port Channel L2, L3 L3 Yes Shutdown (disabled)
VLAN L2, L3 L2 Yes (except default)
L2 - Shutdown (disabled)
L3 - No Shutdown
(enabled)
View Basic Interface Information
To view basic interface information, use the following command.
You have several options for viewing interface status and configuration parameters.
• Lists all configurable interfaces on the chassis.
EXEC mode
show interfaces
This command has options to display the interface status, IP and MAC addresses, and multiple counters for the amount and type of
traffic passing through the interface.
If you configured a port channel interface, this command lists the interfaces configured in the port channel.
NOTE:
To end output from the system, such as the output from the show interfaces command, enter CTRL+C and
Dell EMC Networking OS returns to the command prompt.
NOTE: The CLI output may be incorrectly displayed as 0 (zero) for the Rx/Tx power values. To obtain the correct
power information, perform a simple network management protocol (SNMP) query.
The following example shows the configuration and status information for one interface.
DellEMC#show interfaces tengigabitethernet 1/1
TenGigabitEthernet 1/1 is up, line protocol is up
370
Interfaces