Service Manual

• 8: Creates 498 entries for use by the OpenFlow
controller (512 total entries minus the 14 entries reserved
for internal functionality)
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Added support for the fcoe parameter on the S4810 and
S4820T.
9.1.(0.0) Added support for OpenFlow on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Added the keywords fcoeacl and iscsioptacl on the
S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-
dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
For the new settings to take effect, save the new CAM settings to the startup-
config (write-mem or copy run start) then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires three
blocks and these blocks cannot be reallocated. The ipv4acl profile range is from
1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which
is from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP, to perform a reload on the chassis to upgrade any
configuration changes that have changed the NVRAM content, use the reload
conditional nvram-cfg-change command.
100
Control and Monitoring