Service Manual

Version Description

7.8.1.0 Introduced on the C-Series for the port-channels and the S-

Series.

7.7.1.1 Introduced

Usage Information This command configures an expiration timer for all S.G entries, unless they are

assigned to an Extended ACL.

Even though the FHR nodes act as RPs, these nodes still send Register encap

messages to themselves and expect to receive a Register stop message (for

Anycast RP support). As a result, if the DLT timer expires, SG is not deleted until the

the last Null register is received.

ip pim ssm-range

Specify the SSM group range using an access list.

Syntax

ip pim [vrf vrf-name] ssm-range {access_list_name}

Parameters

vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name

of the VRF to specify the SSM group range for that VRF.

NOTE: Applies to specific VRF if input is provided, else

applies to Default VRF.

access_list_name Enter the name of the access list.

Defaults Default SSM range is 232/8 and ff3x/32

Command Modes CONFIGURATION

Command History

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON. Added support for VRF on

S6000, S4810, S4820T, Z9000, Z9500, and S6000–ON.

9.5(0.1) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.1 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series ExaScale.

7.8.1.0 Introduced on the S-Series.

7.7.1.0 Introduced on the C-Series.

PIM-Sparse Mode (PIM-SM)

1381