Service Manual

Command Modes INTERFACE

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.7(0.0) Introduced on the S-Series, Z-Series, and MXL switch.

Usage Information When you enable ingress sFlow on an interface, flow sampling is done on any

incoming traffic.

NOTE: After a physical port is a member of a LAG, it inherits the sFlow

configuration from the LAG port.

Commands

sflow enable (Global) — turns sFlow globally.

sflow extended-switch enable

Enable packing information on a switch only.

Syntax

sflow extended-switch enable

To disable packing information, use the no sflow extended-switch [enable]

command.

Parameters

enable Enter the keyword enable to enable global extended

information.

Defaults Disabled.

Command Modes CONFIGURATION