Service Manual

ip http vrf
Configures an HTTP client with a VRF that is used to connect to the HTTP server.
Syntax
ip http vrf {management | vrf-name}
To undo the HTTP client configuration, use the ip http vrf command.
Parameters
management Enter the keyword management for configuring the
management VRF that uses an HTTP client.
vrf-name Enter the name of the VRF for configuring a nondefault that
uses an HTTP client.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S4810, S4820T, S5000, S6000, S3048-
ON, S4048-ON, S6000–ON, and Z9500.
Usage Information To make the HTTP clients VRF-aware, use the ip http vrf command. The HTTP
client uses the VRF name that you specify to reach the HTTP server. If you do not
specify a VRF name, then the HTTP client uses the default VRF.
description
Enables you to specify a descriptive name for a customer VRF.
Syntax
description string
To delete the descriptive name for a customer VRF, use the no description
string command.
Parameters
string Enter a descriptive name for the VRF.
Defaults None.
Command Modes VRF MODE
1810
Virtual Routing and Forwarding (VRF)