Service Manual

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
Timer values configured with the neighbor timers command override the timer
values configured with any other command.
When two neighbors, configured with different keepalive and holdtime values,
negotiate for new values, the resulting values are as follows:
• the lower of the holdtime value is the new holdtime value, and
• whichever is the lower value; one-third of the new holdtime value, or the
configured
keepalive value, is the new keepalive value.
neighbor update-source
Enable the E-Series software to use Loopback interfaces for TCP connections for BGP sessions.
Syntax
neighbor {ip-address | peer-group-name} update-source interface
To use the closest interface, use the no neighbor {ip-address | peer-
group-name} update-source interface command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal
format.
peer-group-name Enter the name of the peer group to disable all routers
within the peer group.
interface Enter the keyword loopback then a number of the
Loopback interface. The range is from 0 to 16383.
Defaults Not configured.
Command Modes ROUTER BGP
472
Border Gateway Protocol