Service Manual

NOTE: The MXL and Z9000 platforms currently do not support VRF. These platforms support only

the management and default VRFs, which are available by default. As a result, the feature vrf

command is not available for these platforms.

To display the state of Dell Networking OS features:

Dell#show feature

Example of show feature output

For a particular target where VRF is enabled, the show output is similar to the following:

Feature State

------------------------------

VRF enabled

feature vrf

Enable the VRF application on a switch. After you enable the VRF feature, you cannot deactivate it.

Syntax

feature vrf

Defaults Disabled

Command Modes CONFIGURATION

Command History

Version 9.5(0.0) Introduced on the Z9500.

Version 9.4(0.0) Introduced on the S4810, S4820T, S5000, and S6000.

Usage Information You can activate VRF application on a device by using the feature vrf command

in CONFIGURATION mode. The no feature vrf command is not supported on

any platform.

show feature

Verify the status of software applications, such as VRF, that are activated and running on a device.

Syntax

show feature

Command Modes EXEC

EXEC Privilege

Command History

Version 9.4(0.0) Introduced on the S4810, S4820T, and S6000.

Usage Information You can activate VRF application on a device by using the feature vrf command

in CONFIGURATION mode. The no feature vrf command is not supported on

any of the platforms.

CLI Basics