Service Manual

Version Description
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Example
(Summary)
Dell(conf)# show stack-unit all stack-ports all pfc details
stack unit 1 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
stack unit 2 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
ETS Commands
The following ETS commands are supported on the Dell Networking OS.
bandwidth-percentage
Configure the bandwidth percentage allocated to priority traffic in port queues.
Syntax
bandwidth-percentage percentage
To remove the configured bandwidth percentage, use the no bandwidth-
percentage command.
Parameters
percentage (Optional) Enter the bandwidth percentage. The percentage
range is from 1 to 100% in units of 1%.
Defaults none
Command Modes QOS-POLICY-OUT-ETS
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
Data Center Bridging (DCB)
565