Service Manual

Dell#
Example (Manual
Profiles)
Dell#show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 4
Ipv4Qos : 2
L2Qos : 3
-- Line card 4 --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 4
Ipv4Qos : 2
L2Qos : 3
Dell#show cam-acl
Related
Commands
cam-acl — configures CAM profiles to support IPv6 ACLs.
permit icmp
To allow all or specific internet control message protocol (ICMP) messages, configure a filter.
Syntax
permit icmp {source address mask | any | host ipv6-address}
{destination address | any | host ipv6-address} [message-type]
[count [byte]] | [log] [monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• Use the no permit icmp {source address mask | any | host ipv6-
address} {destination address | any | host ipv6-address}
command.
Parameters
Defaults Not configured.
Command Modes ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
958
IPv6 Access Control Lists (IPv6 ACLs)