Service Manual

show ipv6 cam stack-unit
Displays the IPv6 CAM entries for the specified stack-unit.
Syntax
show ipv6 cam [vrf vrf-name] stack-unit unit-number port-set
{0-1} [summary | index | ipv6 address]
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of
the VRF to display IPv6 CAM entries corresponding to that
VRF.
NOTE: If you do not specify this option, IPv6 CAM
entries corresponding to the default VRF are displayed.
unit-number Enter the stack unit’s ID number.
port-set Enter the keyword Port Set.
summary (OPTIONAL) Enter the keyword summary to display a table
listing network prefixes and the total number prefixes which
can be entered into the IPv6 CAM.
index (OPTIONAL) Enter the index in the IPv6 CAM.
ipv6-address Enter the IPv6 address in the x:x:x:x::x/n format to display
networks that have more specific prefixes. The range is
from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Added support for VRF.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
982
IPv6 Basics