Administrator Guide
The format is aaaa.bbbb.cccc.
Also recongure the same MAC address on the VLT peer switch.
Use this command to minimize the time required for the VLT system to synchronize the default MAC address of the VLT domain on
both peer switches when one peer switch reboots.
7 When you create a VLT domain on a switch, Dell Networking OS automatically assigns a unique unit ID (0 or 1) to each peer switch. To
explicitly congure the default values on each peer switch, use the following command.
VLT DOMAIN CONFIGURATION mode
unit-id {0 | 1}
The unit IDs are used for internal system operations.
Congure a dierent unit ID (0 or 1) on each peer switch.
Use this command to minimize the time required for the VLT system to determine the unit ID assigned to each peer switch when one
peer switch reboots.
8 Congure enhanced VLT. Congure the port channel to be used for the VLT interconnect on a VLT switch and enter interface
conguration mode.
CONFIGURATION mode
interface port-channel id-number
Enter the same port-channel number congured with the peer-link port-channel command in the Enabling VLT and Creating
a VLT Domain
.
9 Place the interface in Layer 2 mode.
INTERFACE PORT-CHANNEL mode
switchport
10 Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to an attached device.
INTERFACE PORT-CHANNEL mode
vlt-peer-lag port-channel id-number
11 Ensure that the port channel is active.
INTERFACE PORT-CHANNEL mode
no shutdown
12 Add links to the eVLT port. Congure a range of interfaces to bulk congure.
CONFIGURATION mode
interface range {port-channel id}
13 Enable LACP on the LAN port.
INTERFACE mode
port-channel-protocol lacp
14 Congure the LACP port channel mode.
INTERFACE mode
port-channel number mode [active]
15 Ensure that the interface is active.
MANAGEMENT INTERFACE mode
no shutdown
1002
Virtual Link Trunking (VLT)