Administrator Guide
To view all congured IP ACLs, use the show ip accounting access-list command in EXEC Privilege mode.
The following examples shows how to view a standard ACL lter sequence for an interface.
Dell#show ip accounting access example interface gig 4/12
Extended IP access list example
seq 15 deny udp any any eq 111
seq 20 deny udp any any eq 2049
seq 25 deny udp any any eq 31337
seq 30 deny tcp any any range 12345 12346
seq 35 permit udp host 10.21.126.225 10.4.5.0 /28 monitor 300
seq 40 permit udp host 10.21.126.226 10.4.5.0 /28
seq 45 permit udp 10.8.0.0 /16 10.50.188.118 /31 range 1812 1813
seq 50 permit tcp 10.8.0.0 /16 10.50.188.118 /31 eq 49 monitor 349
seq 55 permit udp 10.15.1.0 /24 10.50.188.118 /31 range 1812 1813
To delete a lter, enter the show config command in IP ACCESS LIST mode and locate the sequence number of the lter you want to
delete. Then use the no seq sequence-number command in IP ACCESS LIST mode.
Congure an Extended IP ACL
Extended IP ACLs lter on source and destination IP addresses, IP host addresses, TCP addresses, TCP host addresses, UDP addresses,
and UDP host addresses.
The trac passes through the lter in the order of the lter’s sequence and hence you can congure the extended IP ACL by rst entering
IP ACCESS LIST mode, and then assigning a sequence number to the lter.
Conguring Filters with a Sequence Number
To congure lters with a sequence number, use the following commands.
1 Enter IP ACCESS LIST mode by creating an extended IP ACL.
CONFIGURATION mode
ip access-list extended access-list-name
2 Congure a drop or forward lter.
CONFIG-EXT-NACL mode
seq sequence-number {deny | permit} {ip-protocol-number | icmp | ip | tcp | udp} {source mask
| any | host ip-address} {destination mask | any | host ip-address} [operator [portnumber ]
[count [byte]] [order] [monitor [session-id]] [fragments]
When you use the log keyword, the CP logs details about the packets that match. Depending on how many packets match the log entry
and at what rate, the CP may become busy as it has to log these packets’ details.
Congure Filters, TCP Packets
To create a lter for TCP packets with a specied sequence number, use the following commands.
1 Create an extended IP ACL and assign it a unique name.
CONFIGURATION mode
ip access-list extended access-list-name
2 Congure an extended IP ACL lter for TCP packets.
CONFIG-EXT-NACL mode
Access Control Lists (ACLs)
123