Administrator Guide

• IP FIB
• L2 ACL
• L2 FIB
Clearing Interface Counters
The counters in the show interfaces command are reset by the clear counters command. This command does not clear the
counters any SNMP program captures.
To clear the counters, use the following the command.
• Clear the counters used in the show interface commands for all VRRP groups, VLANs, and physical interfaces or selected ones.
Without an interface specied, the command clears all interface counters.
EXEC Privilege mode
clear counters [interface] [vrrp [vrid] | learning-limit]
(OPTIONAL) Enter the following interface keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
• For the Management interface on the stack-unit, enter the keyword ManagementEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• (OPTIONAL) To clear statistics for all VRRP groups congured, enter the keyword vrrp. Enter a number from 1 to 255 as the
vrid.
• (OPTIONAL) To clear unknown source address (SA) drop counters when you congure the MAC learning limit on the interface,
enter the keywords learning-limit.
Example of the clear counters Command
When you enter this command, conrm that you want Dell Networking OS to clear the interface counters for that interface.
Dell#clear counters te 1/1
Clear counters on TenGigabitEthernet 1/1 [confirm]
Dell#
Interfaces
431