Administrator Guide

• The L3 interface conguration should be blocked for RPM VLAN.
• The member port of the reserved VLAN should have MTU and IPMTU value as MAX+4 (to hold the VLAN tag parameter).
• To associate with source session, the reserved VLAN can have at max of only 4 member ports.
• To associate with destination session, the reserved VLAN can have multiple member ports.
• Reserved Vlan cannot have untagged ports
In the reserved L2 VLAN used for remote port mirroring:
• MAC address learning in the reserved VLAN is automatically disabled.
• The reserved VLAN for remote port mirroring can be automatically congured in intermediate switches by using GVRP.
• There is no restriction on the VLAN IDs used for the reserved remote-mirroring VLAN. Valid VLAN IDs are from 2 to 4094. The default
VLAN ID is not supported.
• In mirrored trac, packets that have the same destination MAC address as an intermediate or destination switch in the path used by
the reserved VLAN to transport the mirrored trac are dropped by the switch that receives the trac if the switch has a L3 VLAN
congured.
In a source session used for remote port mirroring:
• You can congure any port as a source port in a remote-port monitoring session with a maximum of three source ports per port pipe.
• Maximum number of source sessions supported on a switch: 4
• Maximum number of source ports supported in a source session: 128
• You can congure physical ports and port-channels as sources in remote port mirroring and use them in the same source session. You
can use both Layer 2 (congured with the switchport command) and Layer 3 ports as source ports. You can optionally congure one or
more source VLANs to specify the VLAN trac to be mirrored on source ports.
• You can use the default VLAN and native VLANs as a source VLAN.
• You cannot congure the dedicated VLAN used to transport mirrored trac as a source VLAN.
• Egressing remote-vlan packets are rate limited to a default value of 100 Mbps. To change the mirroring rate, congure rate-limit within
the RPM session.
In a destination session used for remote port mirroring:
• Maximum number of destination sessions supported on a switch: 64
• Maximum number ports supported in a destination session: 64.
• You can congure any port as a destination port.
• You can congure additional destination ports in an active session.
• You can tunnel the mirrored trac from multiple remote-port source sessions to the same destination port.
• By default, destination port sends the mirror trac to the probe port by stripping o the rpm header. We can also congure the
destination port to send the mirror trac with the rpm header intact in the original mirror trac..
• By default, ingress trac on a destination port is dropped.
Restrictions
When you congure remote port mirroring, the following restrictions apply:
• You can congure the same source port to be used in multiple source sessions.
• You cannot congure a source port channel or source VLAN in a source session if the port channel or VLAN has a member port that is
congured as a destination port in a remote-port mirroring session.
• A destination port for remote port mirroring cannot be used as a source port, including the session in which the port functions as the
destination port.
• A destination port cannot be used in any spanning tree instance.
• The reserved VLAN used to transport mirrored trac must be a L2 VLAN. L3 VLANs are not supported.
Port Monitoring
701