Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

761

762

763

764

765

766

767

768

769

770

INTERFACE mode

ip rip send version [1] [2]

Examples of the RIP Process

To see whether the version command is congured, use the show config command in ROUTER RIP mode.

The following example shows the RIP conguration after the ROUTER RIP mode version command is set to RIPv2. When you set the

ROUTER RIP mode version command, the interface (TenGigabitEthernet 1/1) participating in the RIP process is also set to

send and receive RIPv2 (shown in bold).

To view the routing protocols conguration, use the show ip protocols command in EXEC mode.

Dell#show ip protocols

Routing Protocols is RIP

Sending updates every 30 seconds, next due in 23

Invalid after 180 seconds, hold down 180, flushed after 240

Output delay 8 milliseconds between packets

Automatic network summarization is in effect

Outgoing filter for all interfaces is

Incoming filter for all interfaces is

Default redistribution metric is 1

Default version control:

receive version 2, send version 2

Interface Recv Send

TenGigabitEthernet 1/1 2 2

Routing for Networks:

10.0.0.0

Routing Information Sources:

Gateway Distance Last Update

Distance: (default is 120)

Dell#

To congure an interface to receive or send both versions of RIP, include 1 and 2 in the command syntax. The command syntax for sending

both RIPv1 and RIPv2 and receiving only RIPv2 is shown in the following example.

Dell(conf-if)#ip rip send version 1 2

Dell(conf-if)#ip rip receive version 2

The following example of the show ip protocols command conrms that both versions are sent out that interface. This interface no

longer sends and receives the same RIP versions as Dell Networking OS does globally (shown in bold).