Administrator Guide
In the following example, the bold lines show that 802.1X is enabled.
Dell#show running-config | find dot1x
dot1x authentication
!
[output omitted]
!
interface TenGigabitEthernet 2/1
no ip address
dot1x authentication
no shutdown
!
Dell#
To view 802.1X conguration information for an interface, use the show dot1x interface command.
In the following example, the bold lines show that 802.1X is enabled on all ports unauthorized by default.
Dell#show dot1x interface TenGigabitEthernet 2/1/
802.1x information on Te 2/1/:
-----------------------------
Dot1x Status: Enable
Port Control: AUTO
Port Auth Status: UNAUTHORIZED
Re-Authentication: Disable
Untagged VLAN id: None
Guest VLAN: Disable
Guest VLAN id: NONE
Auth-Fail VLAN: Disable
Auth-Fail VLAN id: NONE
Auth-Fail Max-Attempts: NONE
Mac-Auth-Bypass: Disable
Mac-Auth-Bypass Only: Disable
Tx Period: 30 seconds
Quiet Period: 60 seconds
ReAuth Max: 2
Supplicant Timeout: 30 seconds
Server Timeout: 30 seconds
Re-Auth Interval: 3600 seconds
Max-EAP-Req: 2
Host Mode: SINGLE_HOST
Auth PAE State: Initialize
Backend State: Initialize
Conguring dot1x Prole
You can congure a dot1x prole for dening a list of trusted supplicant MAC addresses. A maximum of 10 dot1x proles can be congured.
The prole name length is limited to 32 characters. The
dot1x profile {profile-name} command sets the dot1x prole mode and
you can enter prole-related commands, such as the
mac command.
To congure a dot1x prole, use the following commands.
• Congure a dot1x prole.
CONFIGURATION mode
dot1x profile {profile-name}
profile—name — Enter the dot1x prole name. The prole name length is limited to 32 characters.
Example of Conguring and Displaying a dot1x Prole
Dell(conf)#dot1x profile test
Dell(conf-dot1x-profile)#
Dell#show dot1x profile
802.1X
93