Service Manual

The range is from 256 to 4294967295.
MD5 | SHA1
Authentication type: Message Digest 5 (MD5) or Secure Hash Algorithm 1 (SHA-1).
key-encryption-
type
(OPTIONAL) Specifies if the key is encrypted.
The values are 0 (key is not encrypted) or 7 (key is encrypted).
key
Text string used in authentication.
For MD5 authentication, the key must be 32 hex digits (non-encrypted) or 64 hex
digits (encrypted).
For SHA-1 authentication, the key must be 40 hex digits (non-encrypted) or 80 hex
digits (encrypted).
Defaults Not configured.
Command Modes ROUTER OSPFv3
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
8.4.2.0 Introduced on the E-Series.
Usage
Information
Before you enable IPsec authentication on an OSPFv3 area, you must first enable OSPFv3 globally on the
router. Configure the same authentication policy (same SPI and key) on each interface in an OSPFv3 link.
An SPI number must be unique to one IPsec security policy (authentication or encryption) on the router.
If you have enabled IPsec encryption in an OSPFv3 area with the area encryption command, you
cannot use the area authentication command in the area at the same time.
The configuration of IPsec authentication on an interface-level takes precedence over an area-level
configuration. If you remove an interface configuration, an area authentication policy that has been
configured is applied to the interface.
To remove an IPsec authentication policy from an OSPFv3 area, enter the no area area-id
authentication spi number command.
Related
Commands
● ipv6 ospf authentication – configure an IPsec authentication policy on an OSPFv3 interface.
● show crypto ipsec policy – display the configuration of IPsec authentication policies.
area encryption
Configure an IPsec encryption policy for OSPFv3 packets in an OSPFv3 area.
Syntax
area area-id encryption ipsec spi number esp encryption-algorithm [key-
encryption-type] key authentication-algorithm [key-encryption-type] key
Parameters
area area-id
Area for which OSPFv3 traffic is to be encrypted. For area-id, enter a number.
Open Shortest Path First (OSPFv2 and OSPFv3) 1037