Service Manual

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-7.7.1.0 Introduced on the E-Series.
Related
Commands
● monitor session — enables a monitoring session.
monitor multicast-queue
Configure monitor QoS multicast queue ID.
Syntax
monitor multicast-queue queue-id
To remove the configuration, use the no monitor multicast-queue command.
Parameters
queue-id Enter the QoS multicast queue ID. The range is from 0 to 9.
Defaults
queue-id: 0
Enable status: Disabled
Command Modes CONFIGURATION
Example
Dell(conf)#monitor multicast-queue 7
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Introduced on the S6000, Z9500, S6000-ON.
Related
Commands
show running-config monitor session — displays information about monitor configurations.
Port Monitoring 1101