Service Manual

Example
Dell# show running-config monitor session
!
monitor session 1
source TenGigabitEthernet 1/1 destination TenGigabitEthernet 1/2
direction rx
!
monitor multicast-queue 7
Dell#
Related
Commands
● monitor session — creates a monitoring session.
● show monitor session — displays a monitoring session.
source (port monitoring)
Configure a port monitor source.
Syntax
source {interface | range | any} destination interface direction {rx | tx |
both}
To disable a monitor source, use the no source interface destination interface
direction {rx | tx | both} command.
Parameters
source interface Enter one of the following keywords and slot/port information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface enter the keyword VLAN followed by a number from 1 to
4094.
● For a port channel interface, enter the keywords port-channel then a
number.
range Enter the keyword range to specify the list of interfaces.
any Enter the keyword any to specify all interfaces.
NOTE: This option is applicable only with drop monitor session.
destination Enter the keyword destination to specify the destination interface.
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
interface Enter one of the following keywords and slot/port information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
● For a port channel interface, enter the keywords port-channel then a
number.
direction {rx | tx
| both}
Enter the keyword direction then one of the packet directional indicators.
● rx: to monitor receiving packets only.
● tx: to monitor transmitting packets only.
● both: to monitor both transmitting and receiving packets.
Defaults none
1106 Port Monitoring