Service Manual

match ip vrf
Uses a VRF as the match criterion for an L3 class map.
S4048–ON
Syntax
match ip vrf vrf-id
To remove VRF as the match criterion, use the no match ip vrf vrf-id command.
Parameters
vlan vlan-id Enter the keyword vrf and then the ID of the VRF. The range is from 1 to 63.
Defaults none
Command Modes CONF-CLASS-MAP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5.(0.1) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage
Information
To access this command, enter the class-map command. After the class map is identified, you can
configure the match criteria.
Use this command to match an IP class-map against a single VRF ID .
Related
Commands
● class-map — identifies the class map.
match mac access-group
Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
S4048–ON
Syntax
match mac access-group {mac-acl-name}
Parameters
mac-acl-name Enter a MAC ACL name. Its contents is used as the match criteria in the class map.
Defaults none
Command Modes CLASS-MAP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
Quality of Service (QoS) 1141