Service Manual

rate-police
Specify the policing functionality on incoming traffic.
S4048–ON
Syntax
rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-
KB]]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps).
Make the following value a multiple of 64. The range is from 0 to 40000000. The
default granularity is Megabits per second (Mbps).
committed-rate Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16 to 200000. The
default is 100.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to specify the peak rate in
Mbps. The range is from 0 to 40000. The default is the same as designated for
committed-rate.
Defaults Burst size is 100KB. peak-rate is by default the same as committed-rate. Granularity for
committed-rate and peak-rate is Mbps unless you use the kbps option.
Command Modes QOS-POLICY-IN
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage
Information
The default burst size is 100Kb. If a different value is required, you must configure the burst size to the
required value.
Related
Commands
● rate police — specifies traffic policing on the selected interface.
● qos-policy-input — creates a QoS output policy.
1150 Quality of Service (QoS)