Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

1161

Table Of Contents

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

6.1.1.1 Introduced on the E-Series.

Usage

Information

Use the default pre-defined profiles or configure your own profile. You cannot delete the pre-defined

profiles or their default values. This command enables WRED configuration mode —(conf-wred).

Commands

● threshold — specifies the minimum and maximum threshold values of the WRED profile.

DSCP Color Map Commands

The DSCP color map allows you to set the number of specific DSCP values to yellow or red. Traffic marked as yellow delivers

traffic to the egress queue which will either transmit the packet if it has available bandwidth or drop the packet due to no ability

to send. Traffic marked as red (high drop precedence) is dropped.

dscp

Sets the number of specific DSCP values for a color map profile to yellow or red.

Syntax

dscp {yellow | red} [list-dscp-values]

To remove a color policy map profile, use the no dscp {yellow | red} [dscp-list] command.

Parameters

Yellow Enter the yellow keyword. Traffic marked as yellow delivers traffic to the egress

queue which either transmits the packet if it has available bandwidth or drops the

packet due to no ability to send.

Red Enter the red keyword. Traffic marked as red is dropped.

dscp-list

Enter a list of IP DSCP values. The dscp-list parameter specifies the full list of IP

DSCP value(s) for the specified color. Each DSCP value in a list is separate values

by commas – no spaces (1,2,3) or indicates a list of values separated by a hyphen

(1-3). Range is 0 to 63.

Defaults None

Command Modes CONFIG-COLOR-MAP