Service Manual

ip rip receive version
To receive specific versions of RIP, set the interface. The RIP version you set on the interface overrides the version command in
ROUTER RIP mode.
S4048–ON
Syntax
ip rip receive version [1] [2]
To return to the default, use the no ip rip receive version command.
Parameters
1 (OPTIONAL) Enter the number 1 for RIP version 1.
2 (OPTIONAL) Enter the number 2 for RIP version 2.
Defaults RIPv1 and RIPv2
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage
Information
If you want the interface to receive both versions of RIP, use the ip rip receive version 1 2
command.
Related
Commands
● ip rip send version — sets the RIP version for sending RIP traffic on an interface.
● version — sets the RIP version the switch software uses.
ip rip send version
To send a specific version of RIP, set the interface. The version you set on the interface overrides the version command in
ROUTER RIP mode.
S4048–ON
Syntax
ip rip send version [1] [2]
To return to the default value, use the no ip rip send version command.
1184 Routing Information Protocol (RIP)