Service Manual

Parameters
ip-address Specify an IP network address in dotted decimal format. You cannot specify a
subnet.
Defaults No RIP network is configured.
Command Modes ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage
Information
You can enable an unlimited number of RIP networks.
RIP operates over interfaces configured with any address the network command specifies.
offset-list
Specify a number to add to the incoming or outgoing route metrics learned using RIP.
S4048–ON
Syntax
offset-list prefix-list-name {in | out} offset [interface]
To delete an offset list, use the no offset-list prefix-list-name {in | out} offset
[interface] command.
Parameters
prefix-list-name Enter the name of an established Prefix list to determine which incoming routes are
modified.
offset Enter a number from zero (0) to 16 to be applied to the incoming route metric
matching the access list specified. If you set an offset value to zero (0), no action
is taken.
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Defaults Not configured.
1188 Routing Information Protocol (RIP)