Service Manual

Remote Monitoring (RMON)
The Dell Networking OS remote monitoring (RMON) is implemented on the S4048–ON platform.
Dell Networking OS RMON is based on IEEE standards, providing both 32-bit and 64-bit monitoring and long-term statistics
collection. Dell Networking OS RMON supports the following RMON groups, as defined in RFC-2819, RFC-3273, RFC-3434, and
RFC-4502:
● Ethernet Statistics Table; RFC-2819
● Ethernet Statistics High-Capacity Table; RFC-3273, 64bits
● Ethernet History Control Table; RFC-2819
● Ethernet History Table; RFC-2819
● Ethernet History High-Capacity Table; RFC-3273, 64bits
● Alarm Table; RFC-2819
● High-Capacity Alarm Table (64bits); RFC-3434, 64bits
● Event Table; RFC-2819
● Log Table; RFC-2819
●
User History; RFC-4502
● Probe Configuration (Capabilities, SoftwareRev, HardwareRev, DateTime and ResetControl); RFC-4502
Dell Networking OS RMON does not support the following statistics:
● etherStatsCollisions
● etherHistoryCollisions
● etherHistoryUtilization
NOTE:
Only SNMP GET/GETNEXT access is supported. Configure RMON using the RMON commands. Collected data is
lost during a chassis reboot.
Topics:
• rmon alarm
• rmon collection history
• rmon collection statistics
• rmon event
• rmon hc-alarm
• show rmon
• show rmon alarms
• show rmon events
• show rmon hc-alarm
• show rmon history
• show rmon log
• show rmon statistics
rmon alarm
Set an alarm on any MIB object.
S4048–ON
Syntax
rmon alarm number variable interval {delta | absolute} rising-threshold
value event-number falling-threshold value event-number [owner string]
To disable the alarm, use the no rmon alarm number command.
47
1200 Remote Monitoring (RMON)