Service Manual

Example
Dell# debug spanning-tree rstp bpdu tengigabitethernet 2/1 ?
in Receive (in)
out Transmit (out)
description
Enter a description of the rapid spanning tree.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
description Enter a description to identify the rapid spanning tree (80 characters maximum).
Defaults none
Command Modes SPANNING TREE (The prompt is “config-rstp”.)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
pre-7.7.1.0 Introduced.
Related
Commands
● protocol spanning-tree rstp — enters SPANNING TREE mode on the switch.
disable
Disable RSTP globally on the system.
Syntax
disable
To enable Rapid Spanning Tree Protocol, use the no disable command.
Defaults RSTP is disabled.
Command Modes CONFIGURATION RSTP (conf-rstp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
Rapid Spanning Tree Protocol (RSTP) 1217