Service Manual

Version Description
E-Series legacy
command
Usage
Information
The following example specifies the group named harig as a version 3 user requiring both authentication
and encryption and read access limited to the read named rview.
NOTE: The number of configurable groups is limited to 16 groups.
Example
Dell# conf
Dell(conf)# snmp-server group harig 3 priv read rview
Dell#
Related
Commands
● show snmp group — displays the group name, security model, view status, and storage type of each
group.
● show running-config — displays the SNMP running configuration.
snmp-server host
Configure the recipient of an SNMP trap operation.
Syntax
snmp-server host ip-address | ipv6-address [vrf vrf-name] traps | informs
[version 1 | 2c | 3] [auth | no auth | priv] [community-string] [udp-port
port-number] [notification-type]
To remove the SNMP host, use the no snmp-server host ip-address [vrf vrf-name]
traps | informs [version 1 | 2c | 3] [auth | noauth | priv] [community-
string] [udp-port number] [notification-type] command.
Parameters
ip-address Enter the keyword host then the IP address of the host (configurable hosts is
limited to 16).
ipv6-address Enter the keyword host then the IPv6 address of the host in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zero.
vrf vrf-name Enter the keyword vrf and then the name of the VRF that the SNMP server uses
to connect to the host.
NOTE: You can use this attribute to inform the SNMP engine about the vrf
instance to be used to reach the corresponding remote host to send Trap or
Inform message. If no VRF is specified, then the default VRF is used.
traps (OPTIONAL) Enter the keyword traps to send trap notifications to the specified
host. The default is traps.
informs (OPTIONAL) Enter the keyword informs to send inform notifications to the
specified host. The default is traps.
version 1 | 2c | 3 (OPTIONAL) Enter the keyword version to specify the security model then the
security model version number 1, 2c, or 3:
● Version 1 is the least secure version.
● Version 3 is the most secure of the security modes.
● Version 2c allows transmission of informs and counter 64, which allows for
integers twice the width of what is normally allowed.
The default is version 1.
auth (OPTIONAL) Enter the keyword auth to specify authentication of a packet
without encryption.
noauth (OPTIONAL) Enter the keyword noauth to specify no authentication of a packet.
1338 Simple Network Management Protocol (SNMP) and Syslog