Service Manual

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Introduced on the E-Series.
storm-control broadcast (Configuration)
Configure the percentage of broadcast traffic allowed in the network.
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast rate-limiting, use the no storm-control broadcast
[packets_per_second in] command.
storm-control broadcast [percentage decimal_value in | out]| [wred-profile name]]
[packets_per_second in]
To disable broadcast rate-limiting, use the storm-control broadcast [percentage decimal_value in | out]
| [wred-profile name]] [packets_per_second in] command.
Parameters
percentagedecim
al_value in | out
Enter the percentage of broadcast traffic allowed in or out of the network.
Optionally, you can designate a decimal value percentage, for example, 55.5%. The
decimal range is from .1 to .9.
wred-profile
name
Enter the keyword wred-profile followed by the profile name to designate a wred-
profile.
packets_per_sec
ond in
Enter the packets per second of broadcast traffic allowed into the network. The
range is from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
1388 Storm Control