Service Manual

threshold-in
msgs count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to
indicate the maximum number of ACL logs that can be generated, exceeding
which the generation of ACL logs is terminated with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes
at which ACL logs must be generated. The threshold range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic
that you want to monitor and the ACL in which you are creating the rule is applied
to the monitored interface. For more information, see “Flow-based Monitoring” in
the Port Monitoring section in the Dell Networking OS Configuration Guide.
Defaults Not configured
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added the monitor option.
6.1.1.0 Introduced on the E-Series.
Usage
Information
When you use the log option, the CP processor logs details about the packets that match. Depending on
how many packets match the log entry and at what rate, the CP may become busy as it has to log these
packets’ details.
NOTE: When you configure the ACL logging and byte counters simultaneously, byte counters may
display an incorrect value. Configure packet counters with logging instead.
Related
Commands
● deny — configure a filter to drop packets.
● permit — configure a filter to forward packets.
Extended MAC ACL Commands
When an access-list is created without any rule and then applied to an interface, ACL behavior reflects implicit permit. The
following commands configure Extended MAC ACLs.
The platform supports both Ingress and Egress MAC ACLs.
NOTE:
For more information, also refer to the Commands Common to all ACL Types and Common MAC Access List
Commands sections.
Access Control Lists (ACL) 207