Service Manual

● If a set action occurs in the first route map entry and then the same set action occurs with a different
value in a subsequent route map entry, the last set of actions overrides the previous set of actions
with the same set command.
● If set community additive and set as-path prepend are configure, the communities and
AS numbers are prepended.
Related
Commands
● set community — specify a COMMUNITY attribute.
● set as-path — configure a filter to modify the AS path.
description
Add a description to this route map.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
description Enter a description to identify the route map (80 characters maximum).
Defaults None
Command Modes ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
pre-7.7.1.0 Introduced.
Related
Commands
● route-map — enable a route map.
match as-path
To match routes that have a certain AS number in their BGP path, configure a filter.
Syntax
match as-path as-path-name
To delete a match AS path filter, use the no match as-path as-path-name command.
Parameters
as-path-name Enter the name of an established AS-PATH ACL, up to 140 characters.
Defaults Not configured.
Command Modes ROUTE-MAP
Access Control Lists (ACL) 219