Service Manual

destination Enter the IP address of the network or host to which the packets are sent.
udf-pkt-format
name
Enter the keywords udf-pkt-format then the UDF ACL profile name.
udf-qualifier-
value name
Enter the keywords udf-qualifier-value then the UDF qualifier value profile
name.
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST mode
CONFIGURATION-EXTENDED-ACCESS-LIST mode
Example
Dell(config-ext-nacl)#deny ip any any udf-pkt-format ipinip udf-
qualifier-value ipnip_val1
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Related
Commands
ip access-list standard — configures a standard ACL.
ip access-list extended — creates an extended ACL.
feature udf-acl
Enable udf-acl feature on a switch.
Syntax
feature udf-acl
To disable the udf-acl feature, use the no feature udf-acl command.
Defaults Disabled
Command Modes CONFIGURATION
Example
Dell(conf)#feature udf-acl
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
key
Configure UDF data context for parsing the different header location offset and required bytes.
Syntax
key description udf-id id packetbase PacketBase offset bytes length bytes
To return to the default settings, use the no key description udf-id id packetbase
PacketBase offset bytes length bytes command.
Parameters
description Enter the key name for reference, up to 64 characters.
Access Control Lists (ACL) 243