Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

351

352

353

354

355

356

357

358

359

360

Table Of Contents

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

7.7.1.0 Introduced on the C-Series.

Usage

Information

This command enables sender-side-loopdetect for a specified BGP neighbor. BGP does not advertise a

route to a peer if the AS-Path of the route already contains the peer's AS.

NOTE: If you configure a neighbor to accept such routes using the neighbor allowas-in

command, you must disable sender-side loop detection for that neighbor.

Commands

● bgp client-to-client reflection — enable route reflection between the route reflector and the clients.

neighbor shutdown

Disable a BGP neighbor or peer group.

Syntax

neighbor {ip-address | peer-group-name} shutdown

To enable a disabled neighbor or peer group, use the neighbor {ip-address | peer-group-

name}no shutdown command.

Parameters

ip-address

Enter the IP address of the neighbor in dotted decimal format.

peer-group-name

Enter the name of the peer group to disable or enable all routers within the peer

group.

Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)

Command Modes ROUTER BGP