Service Manual

Version Description
7.6.1.0 Introduced IPv6 MGBP support for the E-Series.
distance bgp
Configure three administrative distances for routes.
Syntax
distance bgp external-distance internal-distance local-distance
To return to default values, use the no distance bgp command.
Parameters
external-distance Enter a number to assign to routes learned from a neighbor external to the AS. The
range is from 1 to 255. The default is 20.
internal-distance Enter a number to assign to routes learned from a router within the AS. The range
is from 1 to 255. The default is 200.
local-distance Enter a number to assign to routes learned from networks listed in the network
command. The range is from 1 to 255. The default is 200.
Defaults
● external-distance = 20
● internal-distance = 200
● local-distance = 200
Command Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
CAUTION: Dell Networking recommends not changing the administrative distance
of internal routes. Changing the administrative distances may cause routing table
inconsistencies.
The higher the administrative distance assigned to a route means that your confidence in that route is
low. Routes assigned an administrative distance of 255 are not installed in the routing table. Routes from
confederations are treated as internal BGP routes.
Related
Commands
● router bgp — enter ROUTER mode on the switch.
398 Border Gateway Protocol