Service Manual

Field Description
Path Lists all the ASs the dampened route passed through to reach the destination
network.
Example
Dell# show ip bgp dampened-paths
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 192.168.11.5
Status codes: s suppressed, S stale, d dampened, h history, * valid, >
best
Path source: I - internal, a - aggregate, c - confed-external, r -
redistributed
n - network, D - denied, S - stale
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Reuse Path
d 55.0.0.0/24 172.16.0.2 00:36:23 200
Dell#
BGP Extended Communities (RFC 4360)
BGP Extended Communities, as defined in RFC 4360, is an optional transitive BGP attribute.
BGP Extended Communities provides two major advantages over Standard Communities:
● The range is extended from 4-octet (AA:NN) to 8-octet (Type:Value) to provide enough number communities.
● Communities are structured using a new “Type” field (1 or 2-octets), allowing you to provide granular control/filter routing
information based on the type of extended communities.
set extcommunity rt
To set Route Origin community attributes in Route Map, use this feature.
Syntax
set extcommunity rt {as4 ASN4:NN [non-trans] | ASN:NNNN [non-trans] |
IPADDR:NN [non-trans]} [additive]
To delete the Route Origin community, use the no set extcommunity command.
Parameters
as4 ASN4:NN Enter the keyword as4 then the 4-octet AS specific extended community number
in the format ASN4:NN (4-byte AS number:2-byte community value).
ASN:NNNN Enter the 2-octet AS specific extended community number in the format
ASN:NNNN (2-byte AS number:4-byte community value).
IPADDR:NN Enter the IP address specific extended community in the format IPADDR:NN (4-
byte IPv4 Unicast Address:2-byte community value).
additive (OPTIONAL) Enter the keyword additive to add to the existing extended
community.
non-trans (OPTIONAL) Enter the keywords non-trans to indicate a non-transitive BGP
extended community.
Defaults none
Command Modes ROUTE MAP (config-route-map)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
400 Border Gateway Protocol