Service Manual

clear ip bgp ipv6 unicast soft
Clear and reapply policies for IPv6 unicast routes without resetting the TCP connection; that is, perform BGP soft
reconfiguration.
Syntax
clear ip bgp {* | as-number | ipv4-neighbor-addr | ipv6-neighbor-addr |
peer-group name} ipv6 unicast soft [in | out]
Parameters
* Clear and reapply policies for all BGP sessions.
as-number Clear and reapply policies for all neighbors belonging to the AS. The range is from 0
to 65535 (2 Byte), from 1 to 4294967295 (4 Byte), or from 0.1 to 0.65535.65535
(Dotted format).
ipv4-neighbor-
addr | ipv6-
neighbor-addr
Clear and reapply policies for a neighbor.
peer-group name Clear and reapply policies for all BGP routers in the specified peer group.
ipv6 unicast Clear and reapply policies for all IPv6 unicast routes.
in Reapply only inbound policies.
NOTE: If you enter soft, without an in or out option, both inbound and
outbound policies are reset.
out Reapply only outbound policies.
NOTE: If you enter soft, without an in or out option, both inbound and
outbound policies are reset.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.3.19.0 Introduced on the S4820T.
8.4.1.0 Added support for IPv4 multicast and IPv6 unicast routes.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced on the E-Series.
debug ip bgp ipv6 unicast soft-reconfiguration
Enable soft-reconfiguration debugging for IPv6 unicast routes.
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name] ipv6 unicast
soft-reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-address | peer-
group-name] ipv6 unicast soft-reconfiguration command.
404 Border Gateway Protocol