Service Manual

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
hardware-address
For manual configurations, specify the client hardware address.
Syntax
hardware-address address
Parameters
address Enter the hardware address of the client.
Defaults None
Command Modes DHCP <POOL>
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
host
For manual (rather than automatic) configurations, assign a host to a single-address pool.
Syntax
host address
Parameters
address/mask Enter the host IP address and subnet mask.
Defaults None
Command Modes DHCP <POOL>
496 Dynamic Host Configuration Protocol (DHCP)