Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

511

512

513

514

515

516

517

518

519

520

Table Of Contents

Defaults None

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.4.(0.0) Introduced on the S-Series and Z-Series.

Usage

Information

Use this command to associate the system with one or more DNS servers.

In a dual stack setup, the system sends both A (request for IPv4 — RFC 1035) and AAAA (request for

IPv6 — RFC 3596) record requests to a DNS server even if only the ip name-server command is

configured.

Example

• Dell(conf)#ip name-server vrf jay 2.2.2.2

• Dell(conf)#ip name-server vrf jay 2.2.2.2 3.3.3.3 4.4.4.4 5.5.5.5

6.6.6.6 7.7.7.7

ip domain-name

Configures the default domain corresponding to a specific VRF. This domain is appended to the in complete DNS requests

corresponding to the specified VRF.

Syntax

ip domain-name [vrf vrf-name] name

To undo the domain name configuration corresponding to a specific VRF, use the no ip domain-name

[vrf vrf-name] name command.

Parameters

vrf

vrf-name

(Optional) Enter the key word vrf and then the name of the VRF to configure the

domain corresponding to that VRF.

name

Enter the name of the domain to be appended to the in complete DNS requests