Service Manual

Parameters
vrf vrf-name (Optional) Enter the key word vrf and then the name of the VRF to configure the
name server to IP address mapping for that VRF.
name Enter the name od the host to be associated with an IP address.
ip-address Enter the IP address of the name server in dotted decimal format.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage
Information
Use this command to create a mapping between a host name server and its IP addresses for a specific
VRF.
Example
Dell(conf)# ip host vrf jay dell 1.1.1.1
clear host
Removes one or all dynamically learned host table entries for a specific VRF.
Syntax
clear host [vrf vrf-name] {* | host-name}
Parameters
vrf vrf-name (Optional) Enter the key word vrf and then the name of the VRF to delete
dynamically learned host table entries corresponding to that VRF.
host-name Enter the name of the host corresponding to which you want to delete the
dynamically learnt host table entries.
* Enter * to delete all host table entries.
Defaults None
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage
Information
Use this command to delete one or all dynamically learned host table entries corresponding to a specific
VRF.
Dynamic Host Configuration Protocol (DHCP) 521