Service Manual

If you configure a static IPv6 route using an egress interface and enter the ping
command to reach the destination IPv6 address, the ping operation may not work.
Configure the IPv6 route using a next-hop IPv6 address in order for the ping
command to detect the destination address.
interface ip-
address
Enter the keyword interface then the IP address.
distance (OPTIONAL) Enter the value of the distance metric assigned to the route. The
range is from 1 to 255.
permanent (OPTIONAL) Enter the keyword permanent to specify that the route must not be
removed even if the interface assigned to that route goes down. The route must be
currently active to be installed in the routing table. If you disable the interface, the
route is removed from the routing table.
tag tag-value (OPTIONAL) Enter the keyword tag then a number to assign to the route. The
range is from 1 to 4294967295.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF. Use this VRF option
after the next hop to specify which VRF the next hop belongs to. This setting is
used in route leaking cases. See “R”oute Leaking VRFs” in the Virtual Routing and
Forwarding (VRF) section of the Configuration guide.
weight weight-
value
Enter the keyword weight followed by a weight value. The range is from 0 to 255.
NOTE: Weight for a static route can be added only for the destination address
and not for the route pointing to destination a interface.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2.(0.0) Added support for tunnel interface type.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series (the prior limit was 2094).
8.1.1.0 Introduced on the E-Series.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
IPv4 Routing 717