Service Manual

load-balance
By default, for C-Series and S-Series, Dell Networking OS uses an IP 4-tuple (IP SA, IP DA, Source Port, and Destination Port)
to distribute IP traffic over members of a Port Channel as well as equal-cost paths. To designate another method to balance
traffic over Port Channel members, use the load-balance command.
Syntax
load-balance {ip-selection [dest-ip | source-ip]} | {mac [dest-mac |
source-dest-mac | source-mac]} | {tcp-udp | ingress-port [enable]}
To return to the default setting (IP 4-tuple), use the no load-balance {ip-selection [dest-
ip | source-ip]} | {mac [dest-mac | source-dest-mac | source-mac]} | {tcp-
udp | ingress-port [enable]}command.
Parameters
ip-selection
{dest-ip |
source-ip}
Enter the keywords to distribute IP traffic based on the following criteria:
● dest-ip — Uses destination IP address and destination port fields to hash.
The hashing mechanism returns a 3-bit index indicating which port the packet
should be forwarded.
● source-ip — Uses source IP address and source port fields to hash. The
hashing mechanism returns a 3-bit index indicating which port the packet
should be forwarded.
mac {dest-mac |
source-dest-mac
| source-mac}
Enter the keywords to distribute MAC traffic based on the following criteria:
● dest-mac — Uses the destination MAC address, VLAN, Ethertype, source
module ID and source port ID fields to hash. The hashing mechanism returns a
3-bit index indicating which port the packet should be forwarded.
● source-dest-mac — Uses the destination and source MAC address, VLAN,
Ethertype, source module ID and source port ID fields to hash. The hashing
mechanism returns a 3-bit index indicating which port the packet should be
forwarded.
● source-mac — Uses the source MAC address, VLAN, Ethertype, source
module ID and source port ID fields to hash. The hashing mechanism returns
a 3-bit index indicating which port the packet should be forwarded.
tcp-udp enable Enter the keywords to distribute traffic based on the following:
● enable — Takes the TCP/UDP source and destination ports into
consideration when doing hash computations. This option is enabled by default.
ingress-port
enable
Enter the keywords to distribute traffic based on the following:
● enable — Takes the source port into consideration when doing hash
computations. This option is disabled by default.
Defaults IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
720 IPv4 Routing