Service Manual

debug isis local-updates
To debug IS-IS local update packets, enable debugging on a specific interface and provides diagnostic information.
Syntax
debug isis [vrf vrf-name] local-updates [interface]
To turn off debugging, use the no debug isis [vrf vrf—name] updates [interface]
command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable
the debugging information on IS-IS corresponding to that VRF. This information
contains local updates tied to the VRF that you specify. This command displays the
local LSP debugging details of the current unit.
interface (OPTIONAL) Identifies the interface type as one of the following:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.2) Introduced on the Z9000.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
6.3.1.0 Introduced.
debug isis snp-packets
To debug IS-IS complete sequence number PDU (CSNP) and partial sequence number PDU (PSNP) packets, enable debugging
on a specific interface and provides diagnostic information.
Syntax
debug isis [vrf vrf-name] snp-packets [interface]
To turn off debugging, use the no debug isis [vrf vrf-name] snp-packets [interface]
command.
Intermediate System to Intermediate System (IS-IS) 791