Service Manual

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
management-interface
Enable and configure LLDP protocol parameters on the management interface.
Syntax
management-interface
To remove LLDP configuration on a management interface, use the no management-interface
command.
Command Modes LLDP (conf-lldp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.2) Introduced on the Z9000 and S4810.
Usage
Information
To enable LLDP on the management interface, use the no disable command in LLDP-MANAGEMENT-
INTERFACE mode (conf-lldp-mgmtIf).
mode
To receive or transmit, set LLDP.
Syntax
mode {tx | rx}
To return to the default, use the no mode command.
Parameters
tx Enter the keyword tx to set the mode to transmit.
Link Layer Discovery Protocol (LLDP) 885