Service Manual

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Replacement command for the S4820T. Replaces the enable xfp-power-
updates command.
8.3.11.4 Replacement command for the Z9000. Replaces the enable xfp-power-
updates command
8.3.10.0 Replacement command for the S4810 only. Replaces the enable xfp-power-
updates command.
Usage
Information
To enable polling and to configure the polling frequency, use this command.
enable xfp-power-updates
Enable 10–gigabit small form-factor pluggable (XFP) power updates for SNMP.
Syntax
enable xfp-power-updates interval seconds
Parameters
interval seconds Enter the keyword interval then the polling interval in seconds. The range is
from 120 to 6000 seconds. Default: 300 seconds (5 minutes).
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
8.3.19.0 Deprecated command for S4820T. Replaced by the enable optic-info-
update interval command to update information on temperature and power
monitoring in the SNMP MIB.
8.3.11.4 Deprecated command for Z9000. Replaced by the enable optic-info-
update interval command to update information on temperature and power
monitoring in the SNMP MIB.
8.3.10.0 Deprecated command for the S4810 only. Replaced by the enable optic-
info-update interval command to update information on temperature and
power monitoring in the SNMP MIB.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and E-Series.
Usage
Information
The chassis MIB contains the entry chSysXfpRecvPower in the chSysPortTable table. Periodically,
IFA polls the XFP power for each of the ports and sends the values to IFM where it is cached.
To enable polling and to configure the polling frequency, use this command.
92 Control and Monitoring