Service Manual

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Introduced.
Usage
Information
By default, all VLANs are mapped to MST instance zero (0) unless you use the vlan range command
to map it to a non-zero instance.
name
The name you assign to the multiple spanning tree region.
Syntax
name region-name
To remove the region name, use the no name command.
Parameters
region-name Enter the MST region name. The range is 32 character limit.
Defaults No default name.
Command Modes MULTIPLE SPANNING TREE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Introduced.
Usage
Information
For two MSTP switches to be within the same MSTP region, the switches must share the same region
name (including matching case).
922 Multiple Spanning Tree Protocol (MSTP)