Service Manual

NOTE: BGP and ISIS routes are not available on the C-Series. BGP, ISIS, and
RIP routes are not available on the S-Series.
rip (OPTIONAL) Enter the keyword rip to specify that RIP routes are distributed.
NOTE: BGP and ISIS routes are not available on the C-Series. BGP, ISIS, and
RIP routes are not available on the S-Series.
static (OPTIONAL) Enter the keyword static to specify that only manually configured
routes are distributed.
Defaults Not configured.
Command Modes ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for the Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage
Information
The distribute-list out command applies to routes autonomous system boundary routers
(ASBRs) redistributes into OSPF. It can be applied to external type 2 and external type 1 routes, but
not to intra-area and inter-area routes.
fast-convergence
This command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid route computation so that
convergence takes less time.
S4048–ON
Syntax
fast-convergence {number}
To cancel fast-convergence, use the no fast convergence command.
Parameters
number Enter the convergence level desired. The higher this parameter is set, the faster
OSPF converge takes place. The range is from 1 to 4.
Defaults None.
Command Modes ROUTER OSPF
984 Open Shortest Path First (OSPFv2 and OSPFv3)