Service Manual

Parameters
seconds Enter the number of seconds for the interval. The range is from 1 to 65535. The
default is 40 seconds.
Defaults 40 seconds
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage
Information
By default, the dead interval is four times the default hello-interval.
Related
Commands
● ip ospf hello-interval — set the time interval between the hello packets.
ip ospf hello-interval
Specify the time interval between the hello packets sent on the interface.
S4048–ON
Syntax
ip ospf hello-interval seconds
To return to the default value, use the no ip ospf hello-interval command.
Parameters
seconds Enter the number of seconds for the interval. The range is from 1 to 65535. The
default is 10 seconds.
Defaults 10 seconds
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Open Shortest Path First (OSPFv2 and OSPFv3) 991